YASKAWA G7 Series Technical Manual page 235

Switching Acceleration and Deceleration Time Using Multi-Function Input Terminal
Commands
Using the Drive, you can set four acceleration times and four deceleration times. When the multi-function
input terminals (H1- ) are set to 7 (acceleration/deceleration time selection 1) and 1A (acceleration/decel-
eration time selection 2), you can switch the acceleration/deceleration time even during operation by combin-
ing the ON/OFF status of the terminals.
The following table shows the acceleration/deceleration time switching combinations.
Acceleration/Decelera-
tion Time Selection 1
Terminal
OFF
ON
OFF
ON
Switching Acceleration and Deceleration Time Automatically
Use this setting when you want to switch acceleration/deceleration time automatically using the set frequency.
When the output frequency reaches the set value in C1-11, the Drive switches the acceleration/deceleration
time automatically as shown in the following diagram.
Set C1-11 to a value other than 0.0Hz. If C1-11 is set to 0.0Hz, the function will be disabled.
Output frequency
Acceleration/
deceleration time
switching frequency
(C1-11)
When output frequency ≥ C1-11, acceleration and deceleration are performed using
Acceleration/deceleration Time 1 (C1-01, C1-02).
When output frequency < C1-11, acceleration and deceleration are performed using
Acceleration/deceleration Time 4 (C1-07, C1-08).
Fig 6.18 Acceleration/deceleration Time Switching Frequency
Adjusting Acceleration and Deceleration Time Using an Analog Input
If you set H3-09 (Multi-function Analog Input Terminal A2 Function Selection) or H3-05 (Multi-function
Analog Input Terminal A3 Function Selection) to 5 (acceleration/deceleration time gain), you can adjust the
acceleration/deceleration time using terminal A2's input voltage.
The Drive's acceleration time when the acceleration time has been set in C1-01 is as follows:
Acceleration time = C1-01 set value x acceleration/deceleration time gain
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Acceleration/Decelera-
tion Time Selection 2
Terminal
OFF
OFF
ON
ON
C1-07 rate C1-01 rate
Acceleration and Deceleration Characteristics
Acceleration Time Deceleration Time
C1-01
C1-03
C1-05
C1-07
C1-02 rate C1-08 rate
C1-02
C1-04
C1-06
C1-08
17
6-