1.1 Understanding the Parameter Table
1.1
Understanding the Parameter Table
◆ Control Modes, Symbols, and Terms
The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.
Note: For a detailed explanation of each control mode, refer to the FSDrive-MV1000 Instructions (Manual No. EZZ010926).
Symbol
Indicates the parameter is accessible in all control modes.
All Modes
Parameter is available when operating the drive with V/f Control.
V/f
Parameter is available when operating the drive with Open Loop Vector.
OLV
Parameter is available when operating the drive with Closed Loop Vector.
CLV
Indicates this parameter can be changed during run.
Refers to a second motor when the drive is operating two motors. Switch between these motors using the contact
Motor 2
input terminals.
Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.
18
Table 1.1 Symbols and Icons Used in the Parameter Table
Description
YASKAWA ELECTRIC EZZ010930 FSDrive-MV1000 Parameter Guide