YASKAWA G7 Series Technical Manual page 364

Step
Digital Operator Display
No.
5
6
OP→INV COPYING
7
8
During the copy operation, errors may occur. If an error is displayed, press any key to cancel the error display
and return to the 03-01 display.
Error displays and their meanings are shown below. (Refer to Chapter 7 Errors when Using Digital Operator
Copy Function.)
Error Display
ID UNMATCH
INV. KVA UNMATC
CONTROL UNMATCH
COPY ERROR
SUM CHECK ERROR
-146
6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 6.2 COPY Function Procedure
-ADV-
Copy Funtion Sel
Change the set value to 2 using the Increment Key.
o3-01= 2
*0*
OP→INV WRITE
-ADV-
COPY
Set the changed data using the DATA/ENTER Key. The COPY function will start.
-ADV-
COPY
If the COPY function ends normally, End is displayed on the Digital Operator.
COPY COMPLETE
-ADV-
Copy Funtion Sel
The display returns to o3-01 when a key is pressed.
o3 - 01=0
*0*
COPY SELECT
CPE
Drive product code and Drive software number are different.
VAE
Drive capacity with which you are trying to copy, and the Drive capacity stored in the
Digital Operator are different.
The Drive control method in which you are trying to copy, and the Drive control method
CRE
stored in the Digital Operator are different.
CYE
Comparison between the parameter written to the Drive and the parameter in the Digital
Operator shows they are different.
CSE
After copying has ended, comparison between the sum value of the Drive parameter area
and the sum value of the Digital Operator parameter area shows they are different.
Explanation
Meaning