Copying Parameters - YASKAWA CIMR-G7U Technical Manual



Copying Parameters

The Digital Operator can perform the following three functions using the built-in EEPROM (non-volatile
memory).
Store Drive parameter set values in the Digital Operator (READ)
•
Write parameter set values stored in the Digital Operator to the Drive (COPY)
•
Compare parameter set values stored in the Digital Operator with Drive parameters (VERIFY)
•
Related Parameters
Name
Parameter
Number
Display
Copy Function
Selection
o3-01
Copy Function
Sel
Copy Allowed
Selection
o3-02
Read Allowable
Description
This parameter controls the
copying of parameters to and
from the Digital Operator.
0: COPY SELECT (no function)
1: INV --> OP READ - All
parameters are copied from the
Drive to the Digital Operator.
2: OP --> INV WRITE - All
parameters are copied from the
Digital Operator to the Drive.
3: OP<-->INV VERIFY -
Parameter settings in the Drive
are compared to those in the
Digital Operator.
Note: When using the copy
function, the Drive model
number (o2-04), software
number (U1-14), and control
method (A1-02) must match or
an error will occur.
Enables and disables the Digital
Operator copy functions.
0: Disabled - No Digital Operator
copy functions are allowed.
1: Enabled - Copying allowed.
Change
Setting Factory
during
Range Setting
V/f
Operation
0 to 3 0 No A
0 to 1 0 No A
Digital Operator Functions
Control Methods
Open Open
V/f
Loop Flux Loop
with
Vector Vector Vector
PG
1 2
A A A A
A A A A
143
6-