Mac Address And Mac Database Commands; Network Mac-Address; Network Mac-Type - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

4.4 MAC Address and MAC Database Commands

This section describes the commands you use to configure and view information about the
system MAC address and the MAC address table.

4.4.1 network mac-address

This command sets locally administered MAC addresses. The following rules apply:
• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally
administered (b'0') or locally administered (b'1').
• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an
individual address (b'0') or a group address (b'1').
• The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format
Mode

4.4.2 network mac-type

This command specifies whether the switch uses the burned in MAC address or the
locally-administered MAC address.
Default
Format
Mode
4.4.2.1 no network mac-type
This command resets the value of MAC address to its default.
Format
Mode
Port and System Setup Commands
network mac-address
Privileged EXEC
burnedin
{local | burnedin}
network mac-type
Privileged EXEC
no network mac-type
Privileged EXE
v1.0, November 2007
<macaddr>
4-17