Routing Commands; Address Resolution Protocol (Arp) Commands - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

This chapter describes the routing commands available in the 7000 series CLI.
The Routing Commands chapter contains the following sections:
• "Address Resolution Protocol (ARP) Commands" on page 4-1
• "IP Routing Commands" on page 4-8
• "Router Discovery Protocol Commands" on page 4-20
• "Virtual LAN Routing Commands" on page 4-24
• "DHCP and BOOTP Relay Commands" on page 4-25
• "IP Helper Commands" on page 4-27
• "ICMP Throttling Commands" on page 4-30
Warning: The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.

Address Resolution Protocol (ARP) Commands

This section describes the commands you use to configure ARP and to view ARP information on
the switch. ARP associates IP addresses with MAC addresses and stores the information as ARP
entries in the ARP cache.

Routing Commands

v1.0, July 2009
Chapter 4
4-1