Config Forwardingdb Agetime; Device Configuration Commands; Show Switchconfig - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Agetime

config forwardingdb agetime

This command configures the forwarding database address aging timeout. In an IVL system, the
[fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not used and will
be ignored if entered.
Default
Format
Seconds
Forwarding Database ID
database's aging timeout is being configured. All is used to configure all forwarding database's
agetime. In an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered.

Device Configuration Commands

This section describes device configuration commands.

show switchconfig

This command displays switch configuration information.
Format
Broadcast Storm Recovery Mode
802.3x Flow Control Mode
7-24
bases. This field displays the forwarding database ID in an IVL
system. This field will not be displayed in an SVL system.
displays the address aging timeout for the associated forwarding
database in IVL. In an SVL system, this will display the system's
address aging timeout value in seconds.
The default value for <10-1,000,000> is 300 seconds
config forwardingdb agetime <10-1,000,000>
[fdbid/all]
The <seconds> parameter must be within the range of 10 to
1,000,000 seconds.
Fdbid (Forwarding database ID) indicates which forwarding
show switchconfig
May be enabled or disabled by selecting the corresponding
line on the pull-down entry field. The factory default is disabled.
May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is disabled.
May 30, 2003 Beta Draft
Switching Commands