Table of Contents
Advertisement
4.
Slide the latches in and forward to latch in their slots as shown by (1) and (2) in
the following illustration.
5.
Slide the preheater off the shelves and out of the printer as shown by (3).
Replacement Note:
Note
The fingers on the inner simplex guide go over the segmented roller. First
snap the left retainer into place, then the right.
Note
Be sure you do not dislodge the optical sensors while replacing or
reconnecting the pre-heater.
8-28
Latches
WorkCentre C2424 Service Manual
s2424-161
Advertisement
Table of Contents
Troubleshooting
