Xerox WorkCentre C2424DX Service Manual page 154

Jam Code Troubleshooting Procedures
Tray 2 media size sensor unexpectedly activated while print drum maintenance
V2V
cycle was being performed.
Tray 2 media size sensor unexpectedly activated during system imaging.
V2W
Tray 2 media size sensor unexpectedly activated while exiting print.
V2X
Ensure ground integrity of the system (see page 4-73).
1.
Ensure the Tray 2 paper guides are correctly set.
2.
Run the Monitor Sensors test to test the media size sensor.
3.
Replace the media size sensor board.
4.
Replace the pivot arm.
5.
Tray 3 media size sensor unexpectedly activated during warm-up.
W2D
Tray 3 media size sensor unexpectedly activated during system ready.
W2E
Tray 3 media size sensor unexpectedly activated while system in fault state.
W2F
Tray 3 media size sensor unexpectedly activated while system in standby.
W2L
Tray 3 media size sensor unexpectedly activated while picking from Tray 2.
W2M
Tray 3 media size sensor unexpectedly activated while picking from Tray 3.
W2N
Tray 3 media size sensor unexpectedly activated while picking from Tray 4.
W2P
Tray 3 media size sensor unexpectedly activated while picking from Tray 1.
W2Q
Tray 3 media size sensor unexpectedly activated while duplexing.
W2R
Tray 3 media size sensor unexpectedly activated while print drum maintenance
W2V
cycle being performed.
W2x (continued)
Tray 3 media size sensor unexpectedly activated during system imaging.
W2W
Tray 3 media size sensor unexpectedly activated while paper staged for print.
W2S
Tray 3 media size sensor unexpectedly activated while transfixing the print.
W2T
Tray 3 media size sensor unexpectedly activated event while exiting print.
W2X
Ensure ground integrity of the system (see page 4-73).
1.
Ensure the paper guides are correctly set.
2.
Run the Monitor Sensors test to test the media size sensor.
3.
Replace the 525-Sheet Feeder.
4.
Tray 3 motor stall during pick from Tray 3.
W4N
Tray 3 motor stall during pick from Tray 4.
W4P
3-62
(Continued)
WorkCentre C2424 Service Manual