Troubleshooting Procedure (Continued)
Step
Questions and Actions
Inspect the wiper system for improper
6
1.
operation, obstructions, or damage (broken
gear or belt).
Ensure the wiper system is properly aligned
2.
(see "Wiper Alignment" on page 6-2). Also,
see "Homing the Printhead Wiper" on
page 6-4.
Did this correct the problem?
3.
Run the Head Maintenance Clutch test.
7
1.
Did the test pass?
2.
Is the head lock mechanism on the right end
8
1.
of the MEP assembly is functioning
properly?
Are there obstructions or spilled ink on the
9
1.
wiper blade or in the drive path?
8,0XX.6x Errors - Program Faults
a.
Reset NVRAM, and then retest.
b.
Ensure ground integrity for the system (see "Ensuring Ground Integrity" on
page 4-73).
Error Messages and Codes
Yes
Complete.
Go to Step 7.
Go to Step 8.
Replace the
maintenance
clutch.
Go to Step 9.
Replace the
exit assembly.
Clean the inside
Replace the
of the system
exit module
and retest.
assembly.
No
3-21