Table of Contents
Advertisement
Jam Code Troubleshooting Procedures
The exit door open flag unexpectedly tripped when the system picked from Tray 1.
T2Q
The exit door open flag unexpectedly tripped while the system was duplexing.
T2R
The exit door open flag unexpectedly tripped while the paper was staging for the
T2S
transfix cycle.
The exit door open flag unexpectedly tripped while the print was being transfixed.
T2T
The exit door open flag unexpectedly tripped while the system was ejecting the
T2X
print.
The exit door open flag unexpectedly tripped while the system was shutting down.
T2Z
Ensure the media is supported.
1.
Ensure ground integrity of the system, see page 4-73.
2.
Run the Monitor Sensors test.
3.
Inspect the door switch for damage and proper operation.
4.
Check the drum maintenance unit to ensure it is functioning properly and the
5.
blade is not covered with ink debris.
Replace the drum maintenance unit.
6.
Replace the transfix roller.
7.
Tray 2 media size sensor unexpectedly activated during warm-up.
V2D
Tray 2 media size sensor unexpectedly activated during system ready.
V2E
Tray 2 media size sensor unexpectedly activated while system was in a fault state.
V2F
Tray 2 media size sensor unexpected event during oil transfix.
V2K
Tray 2 media size sensor unexpectedly activated while the system was in standby.
V2L
Tray 2 media size sensor unexpectedly activated while picking from Tray 2.
V2M
Tray 2 media size sensor unexpectedly activated while picking from Tray 3.
V2N
Tray 2 media size sensor unexpectedly activated while picking from Tray 4.
V2P
Tray 2 media size sensor unexpectedly activated while picking from Tray 1.
V2Q
Tray 2 media size sensor unexpectedly activated while Duplexing.
V2R
Tray 2 media size sensor unexpectedly activated while paper staged for print.
V2S
Tray 2 media size sensor unexpectedly activated while transfixing the print.
V2T
Error Messages and Codes
(Continued)
3-61
Advertisement
Table of Contents
Troubleshooting
