Table of Contents
Advertisement
3.
Insert the ribbon cables fully and squarely into the ZIF connectors.
Caution
Ensure that the flex cables are inserted into the ZIF connectors on the
printhead fully and squarely. If the cables are inserted incorrectly, they can
short out the Wave Amp.
4.
Connect the data cable connector and heater harness connector.
Caution
The printhead heater cable not only needs to be routed through the cable
restraint, but also needs to be clear of the printhead to prevent interference
which would result in errors 7009 and 4025 fault codes.
Caution
Before reinstalling the printhead, move the wiper all the way down.
5.
Lower the printhead into its mounts. The printhead should be tilted forward in the
print position.
6.
Route the air hose through the frame and connect it to the purge pump.
7.
Install the Roll Block on the left end of the printhead Shaft. The Roll Block must
be oriented as shown on the paper label on the left side of the printer frame.
Caution
Ensure that the printhead restraint does not obstruct the Roll Block.
8.
Install the left and right printhead restraints.
Caution
Ensure that the tilt spring on the left restraint is properly positioned in the
notch on the back of the printhead and does not pinch the air hose.
9.
Set the X-axis bias hook and spring on the end of the left printhead shaft. Ensure
that the point of the hook is centered in the shaft and the rest of the hook floats
freely.
10.
After completing the installation, print the Light Stripes Page and check for jets
in service mode. If necessary, use the control panel to reset the jet substitution
mode.
8-22
WorkCentre C2424 Service Manual
Advertisement
Table of Contents
Troubleshooting
