Xerox WorkCentre C2424DX Service Manual page 136

37,034.43:
PEST - Media path motor disconnect. The media path motor is not
drawing the expected power from the supply.
37,035.44:
PEST - Media path motor short. The media path motor is drawing too
much power from the supply.
Troubleshooting Procedure
Step Questions and Actions
Run the Media Path Motor test.
1
1.
Did the test pass?
2.
Check the wiring for damage.
2 1.
37,036.45:
PEST - Process motor disconnect. The process motor is not drawing the
expected power from the supply.
37,037.46:
PEST - Process motor short. The process motor is drawing too much
power from the supply.
Troubleshooting Procedure
Step Questions and Actions
Do the process drive gears, transfix shaft,
1
1.
and drum maintenance shafts rotate freely?
Run the Process Motor test.
2 1.
Did the test pass?
2.
Check the wiring for damage.
3 1.
37,038.47:
PEST - The power supply did not reset properly as requested. The reset
line may not be connected.
37,039.48:
PEST - Power supply +5 volt over limit.
37,040.40: PEST - Power supply +5 volt under limit .
37,041.41:
PEST - Power supply +1.8 volt over limit.
37,042.42:
PEST - Power supply +1.8 volt under limit.
37,043.43: PEST - Power supply +2.5 volt over limit.
37,044.44:
PEST - Power supply +2.5 volt under limit.
37,045.45:
PEST - Power supply +3.3 volt over limit.
37,046.46:
PEST - Power supply +3.3 volt under limit. (
37,047.47:
PEST - Power supply +12 volt over limit.
3-44
Yes
Replace the
electronics
module.
Replace the media path motor.
Yes
Go to Step 2.
Replace the
electronics
module.
Replace the process drive
assembly.
WorkCentre C2424 Service Manual
No
Go to Step 2.
No
Look for drag in
the rollers or
replace the
process drive.
Go to Step 3.