6,0Xx.4X Errors - X-Axis Fault - Xerox WorkCentre C2424DX Service Manual

6,0XX.4x Errors - X-Axis Fault

6,000.41:
An X-axis motor current error occured.
Troubleshooting Procedure
Step Questions and Actions
Inspect the printhead power cable and
1 1.
heater wiring.
Verify the printhead travels smoothly from
2.
left to right.
Ensure the printhead does not bind due to
3.
ink spills.
Is anything visibly restricting printhead
4.
movement?
Clear the wiring or ink spill, which is
2 1.
restricting movement of the printhead.
Did this correct the problem?
2.
Inspect the X-axis wiring harness.
3 1.
Is the wiring damaged or faulty?
2.
Use service diagnostics to test the X-axis
4 1.
drive.
Did the test fail?
2.
6,0XX.6x Errors - Program Faults
6,001.64:
The X-axis task recieved an unexpected message.
6,002.65:
Attempt to home the X-axis from a state where homing is not allowed.
6,008.62:
Attempt to use the X-axis drive without initializing it.
6,011.65: Attempt to service the X-axis while not in the appropriate state.
6,013.67:
Unknown X-axis program fault.
6,017.62:
An attempt was made to drive the X-axis using the wrong server.
6,018.63:
An attempt was made to move with the X-axis uninitialized.
6,019.64:
An attempt was made to move the X-axis from a homeless state.
6,023.68:
Could not allocate memory for X-axis home parameters.
6,025.66:
An attempt was made to home with the X-axis uninitialized.
6,032.68:
Could not find a solution to the described home motion profile.
6,033.60: Could not allocate memory for X-axis move parameters.
a.
Reset NVRAM, and then retest.
b. Ensure ground integrity for the system (see "Ensuring Ground Integrity" on
page 4-73).
Error Messages and Codes
Yes
Go to Step 2. Go to Step 3.
Complete. Go to Step 3.
Replace the Go to Step 4.
defective wiring.
Replace the X- Replace the
axis motor. electronics
module.
No
3-15