Table of Contents
Advertisement
9.
Disconnect the heater cable and free the cable harness from its restraint.
Cable Restraint
Heater Cable
Heater Harness Plug
10.
Lift the printhead out of its mounting position and place the shaft ends in the
cradle notches near the top of the chassis frame.
11.
Disconnect the data cable from the print head.
8-20
Finger Holes
Data Cable
Cradle Notches
WorkCentre C2424 Service Manual
Cradle Notch
Flex Cables
s2424-276
s2424-157
Advertisement
Table of Contents
Troubleshooting
