1,000.4X Error - 525-Sheet Feeder Faults - Xerox WorkCentre C2424DX Service Manual

1,000.4x Error - 525-Sheet Feeder Faults

1,001.46:
The upper 525-sheet feeder had an overcurrent condition. The lift motor or
clutch may be shorted.
1,002.47: The lower 525-sheet feeder had an overcurrent condition. The lift motor or
clutch may be shorted.
Troubleshooting Procedure
Step Questions or Actions
Unplug all connectors to the optional 525-
1 1.
sheet feeder.
Remove the feeder and inspect the
2.
connector.
Replace any damaged connectors either on
3.
the 525-sheet feeder or engine.
Reseat and reconnect the 525-sheet feeder
4.
to the system.
Did this correct the problem?
5.
Inspect the pick rollers in the 525-sheet
2 1.
feeder tray(s).
Are the pick rollers damaged, dirty, or not
2.
moving freely?
Run the Tray [3]/[4] Pick Clutch test.
3 1.
Does the pick clutch operate correctly?
2.
Run the Tray [3]/[4] Lift Motor test.
4 1.
Does the lift motor operate correctly?
2.
Check the wiring from the 525-sheet feeder
5
1.
to the Electronics Module (J390).
Is the wiring defective?
2.
1,0XX.6x Errors
a.
Reseat the system onto the 525-sheet feeder.
b.
Ensure ground integrity for the system (see "Ensuring Ground Integrity" on
page 4-73).
c.
Reset NVRAM.
d.
Replace the 525-sheet feeder.
Error Messages and Codes
- 525-Sheet Feeder program faults
Yes
Complete. Go to Step 2.
Replace the Go to Step 3.
pick assembly.
Go to Step 4. Replace the
525-sheet
feeder.
Go to Step 5. Replace the
525-sheet
feeder.
Replace the Replace the
wiring and go to 525-sheet
Step 3. feeder.
No
3-9