Table of Contents
Advertisement
Jam Code Troubleshooting Procedures
Tray 4 pick flag triggered unexpectedly while exiting print.
Z2Z
Ensure ground integrity of the system (see page 4-73).
1.
Run the Monitor Sensors test to test the media size sensor.
2.
Replace the 525-Sheet Feeder.
3.
Replace the pivot arm.
4.
Tray 4 pick flag sensor timed out during normal shutdown.
Z3B
Tray 4 pick flag sensor timed out during warm-up.
Z3D
Tray 4 pick flag sensor timed out during wile system ready.
Z3E
Tray 4 pick flag sensor timed out while system in fault state.
Z3F
Tray 4 pick flag sensor timed out while system in standby.
Z3L
Tray 4 pick flag sensor timed out while pick from Tray 2.
Z3M
Tray 4 pick flag sensor timed out while pick from Tray 4.
Z3N
Tray 4 pick flag sensor timed out while pick from Tray 4.
Z3P
Tray 4 pick flag sensor timed out while pick from Tray 1.
Z3Q
Tray 4 pick flag sensor timed out while duplexing.
Z3R
Tray 4 pick flag sensor timed out while the system drum maintenance cycle was
Z3V
being performed.
Tray 4 pick flag sensor timed out while system imaging.
Z3W
Tray 4 pick flag sensor timed out while paper staged for print.
Z3S
Tray 4 pick flag sensor timed out while transfixing the print.
Z3T
Tray 4 pick flag sensor timed out while exiting print.
Z3Z
Verify the paper loaded in Tray 4 is the correct size and type.
1.
Inspect/clean the pick roller assembly. Replace if necessary.
2.
Run the Tray 4 Pick Shaft test
3.
Replace the Tray 4 525-Sheet Feeder.
4.
3-66
(Continued)
WorkCentre C2424 Service Manual
Advertisement
Table of Contents
Troubleshooting
