Xerox WorkCentre C2424DX Service Manual page 104

4,024.42: This fault code indicates a problem with the wiper. The wiper is not
aligned properly and engaged the headtilt while in the waste lock position.
Troubleshooting Procedure
Step Questions and Actions
Run the Check Wiper Alignment test.
1 1.
Did the test fail?
2.
Run the Wiper Drive test.
2 1.
Did the test fail?
2.
Inspect the wiper drive system and wiper
3 1.
lock system. Look for ink in the belts.
Is the wipe system operating correctly?
2.
Inspect the head maintenance clutch.
4 1.
Is there the presence of oil or
2.
contamination?
Run the Head Maintenance Clutch test.
5 1.
Is the head maintenance clutch operating
2.
correctly?
3-12
Yes
Perform the
Wiper
Alignment
Procdure and
test again. Go to
Step 2 if the test
fails again.
Go to Step 3.
Go to Step 4.
Clean the
interior of the
sytem and
replace clutch if
necessary.
Replace in the
following order:
Exit module
Media drive
gearbox
Wiper blade
WorkCentre C2424 Service Manual
No
Go to Step 2.
Go to Step 5.
Replace the
problem
component.
Go to Step 5.
Replace the
head
maintenance
clutch.