2,0Xx.4X Error - I/O Circuit Board Fault; 3,0Xx.6X - Ipc Program Faults - Xerox WorkCentre C2424DX Service Manual

2,0XX.4x Error - I/O Circuit Board Fault

2,001.47:
The print engine cannot detect the presence of the I/O circuit board.
Troubleshooting Procedure
Step Questions or Actions
Are all wiring connections to and from the
1 1.
I/O Board properly seated?
Reseat the connections.
2 1.
Power on the sytem.
2.
Did the error reoccur?
3.
Test the wiring from the I/O board J840 to
3 1.
the power control board J800.
2,0XX.6x Errors - I/O Board Program Faults
2,001.69:
The electronics module failed to initialize.
2,002.61:
This fault code indicates a problem with the system program. The engine
firmware was unable to initialize the queues used for inter-task communication.
2,003.62:
This fault code indicates a problem with the system program. The engine
firmware was unable to start the service diagnostics tasks.
2,004.63:
Failure to start the print engine in suspend mode.
2,005.64:
This fault code indicates a problem with the system program. ROM could
not be opened for reading (idiags).
2,006.65:
This fault code indicates a problem with the system program. ROM could
not be loaded (idiags).
2,007.66:
This fault code indicates a problem with the system program (idiags) entry
point cannot be found.
a.
Reset NVRAM and retest.
b.
Ensure ground integrity for the system (see "Ensuring Ground Integrity" on
page 4-73).
c. Replace the EEPROM chip.
d.
Reboot the system.

3,0XX.6x - IPC Program Faults

There is a communication problem between the engine and PostScript regions.
a.
Reset NVRAM, and then retest.
b.
Replace the EEPROM chip.
3-10
Yes
Go to Step 3.
Go to Step 3.
Replace the I/O Board.
WorkCentre C2424 Service Manual
No
Go to Step 2.
Complete.