Xerox WorkCentre C2424DX Service Manual page 147

Jam Code Troubleshooting Procedures
The front door open flag unexpectedly tripped while the system was warming up.
F2D
The front door open flag unexpectedly tripped while the system was in a fault state.
F2F
The front door open flag unexpectedly tripped when the system pick from Tray 2.
F2M
The front door open flag unexpectedly tripped when the system pick from Tray 3.
F2N
The front door open flag unexpectedly tripped when the system pick from Tray 4.
F2P
The front door open flag unexpectedly tripped when the system pick from Tray 1.
F2Q
The front door open flag unexpectedly tripped while the system was duplexing.
F2R
Front door sensor unexpectedly actuated while the paper was staged for transfix.
F2S
The front door open flag unexpectedly tripped while the print was being transfixed.
F2T
The front door open flag unexpectedly tripped while the system was oiling the drum
F2V
during a print job.
The front door open flag unexpectedly tripped while the system was imaging during
F2W
a print job.
Front door sensor unexpectedly actuated during exit.
F2X
Ensure the media is supported.
1.
Ensure ground integrity of the system, see page 4-73.
2.
Run the diagnostic Sensors test to test the door sensor.
3.
Check that the doors and covers are properly closed and seated.
4.
Run the door sensor test.
5.
Tray 2 removed during pick from Tray 2.
G2M
Tray 3 was removed during pick from Tray 3.
H2N
Tray 4 was removed during pick from Tray 4.
J2M
Tray 4 media present sensor event pick from Tray 4.
J2P
Exit module (MEP) malfunction during an abnormal IIT device shutdown.
K2A
Exit module (MEP) malfunction during a normal IIT device shutdown.
K2B
Exit module (MEP) malfunction during mechanical recovery.
K2C
Exit module (MEP) malfunction during warm-up.
K2D
Exit module (MEP) malfunction while in ready state.
K2E
Exit module (MEP) malfunction while in a fault state.
K2F
Exit module (MEP) malfunction during transfix.
K2T
Error Messages and Codes
(Continued)
3-55