Xerox WorkCentre C2424DX Service Manual page 155

Jam Code Troubleshooting Procedures
Tray 3 motor stall during pick from Tray 3.
W4S
Ensure ground integrity of the system (see page 4-73).
1.
Ensure the paper guides are correctly set.
2.
Run the Monitor Sensors test to test the media size sensor.
3.
Replace the 525-Sheet Feeder.
4.
Tray 3 pick flag triggered unexpectedly during abnormal shutdown.
X2A
Tray 3 pick flag triggered unexpectedly on power-up following normal shutdown.
X2B
Tray 3 pick flag triggered unexpectedly during mechanical recovery.
X2C
Tray 3 pick flag triggered unexpectedly during warm-up.
X2D
Tray 3 pick flag triggered unexpectedly during system ready.
X2E
Tray 3 pick flag triggered unexpectedly while system was in a fault state.
X2F
Tray 3 pick flag triggered unexpectedly while system in standby.
X2L
Tray 3 pick flag triggered unexpectedly while picking from Tray 2.
X2M
Tray 3 pick flag triggered unexpectedly while picking from Tray 3.
X2N
Tray 3 pick flag triggered unexpectedly while picking from Tray 4.
X2P
Tray 3 pick flag triggered unexpectedly while picking from Tray 1.
X2Q
Tray 3 pick flag triggered unexpectedly while duplexing.
X2R
Tray 3 pick flag triggered unexpectedly while transfixing.
X2S
Tray 3 pick flag triggered unexpectedly while print drum maintenance cycle was
X2V
being performed.
Tray 3 pick flag triggered unexpectedly during system imaging.
X2W
X2x (continued)
Tray 3 pick flag triggered unexpectedly while exiting print.
X2X
Ensure ground integrity of the system (see page 4-73).
1.
Ensure the paper guides are correctly set.
2.
Run the Monitor Sensors test to test the media size sensor.
3.
Replace the 525-Sheet Feeder.
4.
Replace the pivot arm.
5.
Tray 3 pick flag sensor timed out during warm-up.
X3D
Tray 3 pick flag sensor timed out during wile system ready.
X3E
Tray 3 pick flag sensor timed out while system in fault state.
X3F
Tray 3 pick flag sensor timed out while system in standby.
X3L
Error Messages and Codes
(Continued)
3-63