High Capacity Feeder Error Code Table
This table lists all of the High Capacity Feeder related Error Codes that are generated by
the Print Engine Controller Board.
Depending on the level of firmware on your Print Engine
Note
Controller Board some codes listed in this table may be invalid,
some codes generated by the Print Engine Controller may not
appear in this table, and Error and Message Code text presented
in this table may differ slightly from the Error and Message Code
text that is actually generated by your Print Engine Controller.
Table 2-3 High Capacity Feeder Error Code Table
Displayed
Error
Error
Code
Message
Paper Jam
C3-2
Clear Areas A,
B
Paper Jam
C3-3
Clear Area A,
B
Clear Area C
C4-0
Reset Tray 4
Paper Jam
C4-1
Clear Areas B,
C
Paper Jam
C4-2
Clear Areas A,
B, C
2-370
DocuPrint N4525 Network Printer - Service Guide
Error Description
There is a paper jam between Tray 3 and Tray 2
Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that the Tray 2 Take Away Sensor did not
actuate within the specified time after the Tray 3
Feed Clutch was actuated.
There is a paper jam between Tray 3 and the
Registration Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 3, the
Registration Sensor did not actuate within the
specified time after the Tray 2 Take Away Sensor
actuated.
There is a paper jam between Paper Tray 4 and
the Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Tray 3 Take Away Sensor did not actuate within the
specified time after the Tray 4 Feed Clutch was
actuated.
There is a paper jam between Paper Tray 4 and
the Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Tray 3 Take Away Sensor did not actuate within the
specified time after the Tray 4 Feed Clutch was
actuated.
There is a paper jam between Tray 2 Take Away
Sensor and Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Tray 2 Take Away Sensor did not actuate within the
specified time after the Tray 3 Take Away Sensor was
actuated.
Go to
Unit/
RAP
Page
No.
No.
2-1
2-373
2-2
2-375
2-20
2-407
2-3
2-377
2-4
2-379