Main Menu - Danfoss VLT Micro Drive FC 51 Series Operating Instructions Manual

4 Programming
7-38 Process Feed Forward Factor
Range:
[0 - 400%]

4.5 Main Menu

The Main Menu gives access to all parameters.
1. To enter the Main Menu, press [MENU] key until indicator in
4
display is placed above
▲ ▼
2.
Use [ ] [ ] to browse through the parameter groups.
3. Press [OK] to select a parameter group.
▲ ▼
4.
Use [ ] [ ] to browse through the parameters in the specific
group.
5. Press [OK] to select the parameter.
▲ ▼
6.
Use [ ] [ ] to set/change the parameter value.
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice to enter
[Menu] once to enter
24
Function:
Only applicable with changing set-points.
Main Menu
.
Quick Menu , or press
Status .
MG.02.A4.02 - VLT
®
VLT Micro Drive FC 51 Operating Instructions
Illustration 4.10: Indicating Main Menu mode
®
is a registered Danfoss trademark