Step 10. Trim Draper Deflectors; Step 11. Adjust Transport Lights; Step 12. Install Options - MacDon Harvest Header D65 Assembly Instructions Manual

STEP 10. TRIM DRAPER
DEFLECTORS
a. Trim existing deflectors as follows:
A
4 in. (100 mm)
b. Mark a straight line (A) on the deflector 4 in.
(100 mm) from and parallel to the back edge of
the deflector.
c. Mark another line (B) on the deflector 4 in.
(100 mm) from and parallel to the endsheet.
d. Using a sharp knife, cut rubber deflector along the
lines (A) and (B), taking care not to cut the draper
underneath the deflector.
e. Cut the rubber deflector along the steel retainer
(C) from the inboard edge up to line (B), and
remove the excess rubber.
DEFLECTOR AFTER TRIMMING
f. Use the cut-off portion of deflector as a template
to re-work the deflector on the opposite end.
169603
UNLOADING AND ASSEMBLY
B
C
26
STEP 11. ADJUST TRANSPORT
LIGHTS
a. Position light perpendicular to header. Lights are
located on each of the outboard reel arms.

STEP 12. INSTALL OPTIONS

Optional attachments and kits may have been
supplied with the header, and should be installed
at this time.
They include all necessary hardware and
installation instructions.
Revision B