9. Pull
pin
(A)
at
counterclockwise to position shown and lock with
pin (A).
10. Remove hairpin (B) from latch (C).
11. Lift wheel, lift latch (C), and engage lug (D) onto left
axle. Ensure latch closes.
12. Secure latch with hairpin (B), with open end of pin
facing rear of combine.
NOTE: Installing hairpin with the open end facing
the cutterbar will cause it to be dislodged
by crop during operation.
IMPORTANT
Check that wheels are locked and that handle is in
locked position.
13. The conversion is complete when the wheels are as
shown. In the image to the right, (A) shows Field
position on left side.
right side.
4.15.4 Converting from Field to Transport Position
To convert the header from field to transport position, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. See your windrower
operator's manual for instructions for use and storage of header safety props.
Moving Left (Front) Wheels into Transport Position
To move the left transport wheels into transport position,
follow these steps.
169594
OPERATION
right
wheel,
swivel
(B) shows Field position on
wheel
Figure 4.83: RH side
A - Pin
C - Latch
Figure 4.84: Field position - (A) shows left side;
(B) shows right side
97
B - Hairpin
D - Lug
Rev. C