8-9: Common Fx Lfo - Korg KRONOS SGX-2 Parameter Manual

8–9: Common FX LFO
1–1b
8–9a
8–9b
The two Common FX LFOs allow you to synchronize LFO-
based modulation for multiple effects, such as phasers,
flangers, filters, and so on.
The Common LFOs control only the frequency, MIDI
synchronization, and reset options; each individual effect
still has its own settings for the LFO waveform and phase.
Within the individual effects, you can choose whether to use
one of the Common LFOs, or to use the individual effect's
frequency, sync, and/or reset settings instead. This is done
via the effect's LFO Type parameter; select Individual to
use the effect's settings, or Common 1 or 2 to use the
Common LFOs.
8–9a: Common FX LFO1
Ch (Control Channel)
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for Common LFO 1 and 2.
G ch: The global MIDI channel (Global 1–1a) will be used
for control. This is the default setting.
Sync (Reset)
Source (Dmod Source)
Frequency
MIDI/Tempo Sync
BPM
[r , x 3 , x , e 3 , e , q 3 , q , h 3 , h , w]
Base Note
[Ch01...Ch16, Gch]
[Off, On]
[List of Dmod Sources]
[0.02...20.00 (Hz)]
[Off, On]
[MIDI, 40.00...300.00]
Sequencer P8: Insert Effect 8–9: Common FX LFO
Times
These parameters are the same as in Program mode. For
more information, please see "8–9a: Common FX LFO1" on
page 147.
8–9b: Common FX LFO2
These parameters are the same as for Common FX LFO1.
For more information, please see "8–9a: Common FX
LFO1," above.
v 8–9: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 153.
• 0: Memory Status. For more information, see "Memory
Status" on page 637.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
• 2: Copy Insert Effect. For more information, see "Copy
Insert Effect" on page 166.
• 3: Swap Insert Effect. For more information, see "Swap
Insert Effect" on page 166.
• 4: Put Effect Setting To Track. For more information,
see "Put Effect Setting to Track" on page 670.
• 5: FF/REW Speed. For more information, see "FF/REW
Speed" on page 638.
• 6: Set Location (for Locate Key.) For more information,
see "Set Location (for Locate Key)" on page 639.
8–9PMC
[01...32]
633