Korg KRONOS SGX-2 Parameter Manual page 758

Sampling mode
Auto Resample through IFX
If you select Auto Resample through IFX:
1. Use "IFX" to select the effect that you want to apply
to the sample.
2. Press the OK button to execute Auto Sampling Setup
(Auto Resample through IFX), or press the Cancel
button if you decide not to execute. For more
information, please see "Auto Sampling Setup:
Automatically-set parameters and their values" on
page 745.
When you are ready to resample (after executing Auto
Resample through IFX), perform the following steps.
3. Use Key (0–8c) to specify the key to which the sample
you want to resample is assigned.
4. Use P8: Insert Effect to make effect settings. To hear
the sound, play the note you specified in Key.
5. To begin resampling, press the SAMPLING REC key
and then the SAMPLING START/STOP switch. (This
is because Trigger is set to Sampling START SW.) The
sample will play, and when playback ends, it will be
resampled.
To check the resampled data, play the note you specified in
the Key parameter.
To prevent the insert effect from being applied a second
time when you listen to the resampled data, "Bus Select
All OSCs to" (8–1b) will automatically be set to L/R
when resampling is complete. If you want to apply IFX
and resample once again, you will need to change this
setting back to the same IFX.
744