012: Stereo Graphic 7Eq - Korg KRONOS SGX-2 Parameter Manual

Table of Contents

Advertisement

GAIN MOD
D
-mod
+15dB
+6dB
0dB
Band2 Cutoff
Band2 Gain[dB]= +6.0
Band2 Gain Mod Amount[dB]= +9.0

012: Stereo Graphic 7EQ

On-screen graphic, 012: Stereo Graphic 7EQ
Purple area: This shows the frequency response
after passing through all of the bands.
Vertical axis: Gain (dB)
Horizontal axis:
Frequency (Hz)
These sliders adjust the
gain (dB) of each band.
This line shows the center
frequencies of the selected Type.
This is a stereo 7-band graphic equalizer. The bar graph of
the gain setting for each band gives you a clear, visual idea
of frequency responses. You can select a center frequency
setting for each band from twelve types, according to the
sound.
Stereo In - Stereo Out
Left
Trim
Band1 Band2 Band3 Band4
Trim
Band1 Band2 Band3 Band4 Band5 Band6 Band7
Right
Parametric 4EQ - Band2 Gain Mod
Band2 Cutoff
+6dB
0dB
—9dB
D
-mod
Band2 Gain[dB]= +6.0
Band2 Gain Mod Amount[dB]= —15.0
Red lines show the center frequencies of each band.
Wet / Dry
Band5 Band6 Band7
Wet / Dry
EQ and Filters 012: Stereo Graphic 7EQ
Band2 Source
Selects the modulation source for the Band 2 gain.
Amount [dB]
Sets the modulation amount for the Band 2 gain.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
GRAPHIC EQ
Type
[1:Wide 1, 2:Wide 2, 3:Wide 3,
4:Half Wide 1, 5:Half Wide 2, 6:Half Wide 3,
7:Low, 8:Wide Low, 9:Mid, 10:Wide Mid,
This parameter selects a combination of center frequencies
for each band. Each center frequency is shown on the bottom
of the Gain slider.
You can configure a 21-Band Graphic EQ ranging from
80Hz to 18kHz if you route three Graphic 7Band EQ effects
in series, with a setting of 7:Low, 9:Mid, and 11:High for
each EQ.
Trim
Sets the input level
(Band1...8 Gain [dB])
These controls set the gain for each of the eight bands.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
[Off...Tempo]
[–18.0...+18.0]
The selected band
is indicated by a
thick red line.
Green line: Shows
the frequency response
of the selected band
alone, without the results
of the other bands.
11:High, 12:Wide High]
[0...100]
[–18.0...+18.0]
917

Advertisement

Table of Contents
loading

Table of Contents