Table of Contents
Advertisement
EXi: MOD-7 Waveshaping VPM Synthesizer
5–2b: Velocity Graphic
Velocity zone graphic
This is a graphic representation of the velocity zones for
MS1–4. The currently selected MS is shown in green.
On
This mutes and un-mutes the PCM Oscillator, for quick
comparisons during editing. This checkbox is also shown in
the Parameter Details on the Patch Panel.
Note that the PCM Oscillator will still use processing power
unless it is not connected on the Patch Panel, or all MS are
set to Off. For more information, see "Disabling the PCM
Oscillator" on page 368.
5–3: PCM Mod
5–3a
This page provides control of pitch and volume settings and
modulation for the PCM Oscillator.
5–3a: Pitch
Octave
This sets the basic pitch of the PCM Oscillator, in octaves.
The default is +0[8'].
Transpose
This adjusts the pitch in semitones, over a range of ±1
octave.
Tune
This adjusts the pitch in cents, over a range of ±1 octave. A
cent is 1/100 of a semitone.
370
[Checkbox]
[–2[32'], –1[16'], +0[8'], +1[4']]
[–12...+12]
[–1200...+1200]
v 5–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 153.
• 0: Write Program. For more information, see "Write
Program" on page 153.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
• 2: Copy VPM Oscillator. For more information, see
"Copy VPM Oscillator" on page 395.
• 3: Swap VPM Oscillators. For more information, see
"Swap VPM Oscillators" on page 395.
• 4: Remap MS/Sample Banks. For more information,
see "Remap MS/Sample Banks" on page 170.
Frequency Offset
This adjusts the pitch by increments of 0.1 Hz. Frequency
Offset is different from Tune in that, when used to detune
the two oscillators, it can create a constant beat frequency
across the range of the keyboard.
Pitch Parameter Details
These items appear in the Parameter Details area when any
of the Pitch parameters are selected.
Use Common Mod
When off, the oscillator still responds to the Pitch and
Portamento settings from Pitch Common, but ignores the
LFO and AMS settings.
AMS1
This selects the first modulation source for controlling the
oscillator's pitch. For a list of AMS sources, see "Alternate
Modulation Source (AMS) List" on page 1109.
5–3PMC
5–3d
5–3b
5–3c
[–10.0Hz...+10.0Hz]
[Checkbox]
[List of AMS Sources]
Advertisement
Table of Contents
