Korg KRONOS SGX-2 Parameter Manual page 719

Select/Solo (1–6)
This switch either selects or solos the input, depending on
the Solo switch setting. For more details, see "Solo," above.
MIX VOLUMES sliders 1–6
Audio Input Volume (1–6)
These sliders adjust the volume levels of the audio inputs.
The meters to the left of the sliders show the audio input
levels, before the volume controls, in realtime.
0–9d
0–9d: External
This Control Assign setting lets you send MIDI messages to
external devices. Each slider, knob, and switch can be
assigned to a separate MIDI controller and MIDI channel.
The eight drum pads also have separate settings which apply
only when Control Assign is set to External.
In Global mode, you can create up to 128 different External
Setups. For instance, you might make one setup for
controlling several different pieces of MIDI gear on stage,
another for controlling a software synthesizer (such as one of
Korg's Legacy Collection synths), and so on. For more
information, see "1–2: External 1" on page 788.
These External Setups are completely separate from the
Program. You can think of External mode as being a separate
control surface which just happens to share KRONOS's
sliders, knobs, switches, and drum pads.
When you select an External Setup, it stays selected even
when you change Programs, or switch to Combi or
Sequencer modes. This makes it easy to select different
KRONOS sounds without disrupting any external MIDI
control, and vice-versa.
Setup
This selects the Global setup for the knobs, sliders, switches,
and drum pads.
Note: this selection is not stored with the Program.
Sampling P0: Recording 0–9: Control Surface
Master Volume Slider
[Off, On]
Master Volume
This controls the volume of the main stereo outputs, after the
Total Effects. It does not affect Individual Outputs 1–4. For
more information, see the diagram "Master Volume" on
[000...127]
page 703.
The stereo meter to the left of volume control shows the
audio levels at the main output, including clipping.
Knobs 1–8
MIDI Channel (1–8)
This read-only parameter shows the MIDI Channel assigned
to the knob. Each can send on a different channel, if desired.
Gch means that the knob will transmit on the Global MIDI
Channel, as set in Global mode. This allows you to re-direct
any number of sliders, knobs, switches, and pads to a
different channel at once, without editing the individual
controls.
CC# Assign (1–8)
This read-only parameter shows the MIDI CC sent by the
knob.
Value (1–8)
This is the current value of the knob's MIDI CC.
Switches 1–16
MIDI Channel (1–16)
This read-only parameter shows the MIDI Channel for the
switch. Each can send on a different channel, if desired.
Gch means that the slider will transmit on the Global MIDI
[000...127]
Channel, as set in Global mode.
CC# Assign (1–16)
This read-only parameter shows the MIDI CC sent by the
switch.
[000...127]
[(01...16, Gch)]
[(Off, 000...119)]
[000...127]
[(01...16, Gch)]
[(Off, 000...119)]
705