Table of Contents
Advertisement
Effect Guide
The following diagram (Fig. 2–2a) shows an example of
Combination mode. The Timbre 1 output is sent to IFX1 and
the Timbre 2 output is sent to IFX2 according to the Bus
Fig. 2–2a
In the diagram (Fig. 2–2b), IFX1's Chain check box is
checked and Chain to set to IFX2, sending the output of
IFX1 to IFX2. Timbre 1 is being processed by IFX1: 001:
Stereo Dyna Compressor and IFX2: 048: Stereo Flanger
Fig. 2–2b
882
Select setting. Other timbres are sent to L/R. The output
signal passes through the TFX1 and 2, then goes to AUDIO
OUTPUT (MAIN) L/MONO and R.
effects. Timbre 2 is being processed by the IFX2: 048:
Stereo Flanger effect. The Routing Map area of the diagram
(Fig. 2–1a) shows these settings. (With these settings, IFX3–
12 are not being used.)
Advertisement
Table of Contents
