010: Stereo Noise Reduction - Korg KRONOS SGX-2 Parameter Manual

Polarity
This controls the way that the gate opens and closes in
response to the input signal.
+: This is the default setting, for normal gate behavior. The
gate will open when the input is above the Threshold, and
close when the input falls below it.
–: This reverses the normal operation. The gate will close
when the input is above the Threshold, and open when the
input falls below it.

010: Stereo Noise Reduction

This effect minimizes obtrusive noise by reducing the
volume when the signal is at a low level. You can use this if
a guitar or mic signal from the audio input contains noise.
Stereo In - Stereo Out
Left
Envelope Select
Envelope - Control
Envelope Source
Right
FX Control BUS 1
FX Control BUS 2
ENVELOPE
Envelope Source [Input, FX Control 1, FX Control
Selects the trigger source to use: the input signal, FX Control
Bus 1, or FX Control Bus 2. p.905.
Envelope Select
Selects whether the compressor is linked between left/right,
controlled only by the left signal, only by the right signal, or
independently for left and right. p.905.
Fx Control Trim
This adjusts the level of the FX Control Bus inputs.
NOISE REDUCTION
Trigger Monitor
Switches between monitoring the effect output and the
trigger signal. p.910.
Threshold [dB]
Sets the noise level
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
[+, –]
Wet / Dry
Trigger Monitor
Wet / Dry
2]
[L/R Mix, Left, Right]
[0...100]
[Check-box]
[–72.0...–22.0]
Dynamics 010: Stereo Noise Reduction
With –, the direction in which the modulation source opens
or closes the gate is reversed as well.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
On-screen graphic, 010 Stereo Noise Reduction
This is a realtime indication of the control input signal level (Input),
the gain reduction produced by the control input signal (Gain
Reduce), and the output signal level (Output).
Noise Reduction reduces the noise level below the Threshold.
915