Mod-7: Tone Adjust; Common Tone Adjust Parameters; Mod-7 Tone Adjust Parameters - Korg KRONOS SGX-2 Parameter Manual

MOD-7: Tone Adjust

MOD-7 Tone Adjust Default Settings
Switches 1-6: Switches 1-6:
VPM Osc 1-6 VPM Osc 1-6
On/Off On/Off
Switches 9 & 10: Switches 9 & 10:
PCM On & Reverse PCM On & Reverse
Tone Adjust provides an elegant physical interface to the
MOD-7's parameters. Most of the factory sounds use the
default layout, as shown above. You can also customize the
layout for individual sounds, if desired.
For more information about Tone Adjust, please see "0–9f:
Tone Adjust," on page 35.

Common Tone Adjust parameters

Except as noted below, the Common Tone Adjust parameters
behave as described under "Common Tone Adjust
Parameters," on page 37.
Filter/Amp EG Attack Time.
(–99...+99, CC#73)
This scales the attack time of EG8 and the Amp EG. It
interacts with CC# 73.
Filter/Amp EG Decay Time.
(–99...+99, CC#75)
This scales the decay time of EG8 and the Amp EG. It
interacts with CC# 75.
Filter/Amp EG Sustain Level.
(–99...+99, CC#70)
This scales the sustain levels of EG8 and the Amp EG. It
interacts with CC# 70.
Filter/Amp EG Release Time.
(–99...+99, CC#72)
This scales the release time of EG8 and the Amp EG. It
interacts with CC# 72.
Filter EG Attack Time, Decay Time, Sustain Level, and
Release Time apply to EG8.
Pitch EG Attack Time, Decay Time, Sustain Level, and
Release Time are not supported by the MOD-7.
MOD-7: Tone Adjust Common Tone Adjust parameters
VPM Osc 1-6 Ratio VPM Osc 1-6 Ratio
VPM Osc 1-6 Output Level VPM Osc 1-6 Output Level

MOD-7 Tone Adjust parameters

In addition to the Common Tone Adjust parameters listed
above, the MOD-7 adds a number of its own parameters.
Note that these additional parameters are separate for each
EXi, as opposed to being shared by both EXi in the Program.
All of the additional parameters are listed below. Tone
Adjust parameters may affect the internal parameters in one
of two ways: they may be Relative, in which case they scale
the existing parameter value, or Absolute, in which case
they over-write the existing value. Unless otherwise noted,
all of the MOD-7 parameters are Absolute.
The full name of the currently selected parameter is shown
in the status line at the top of the Control Surface page, as
well as in the popup menu. Some parameters with longer
names may show an abbreviation for the slider, knob, and
switch labels.
Macro Parameters
Brightness
Brightness Vel Sens
Timbre
Feedback
Detune
Noise
Saturation
Filter Freq
PCM Oscillator
On/off
MS Select
MS Bank
Filter A Filter A Filter B Filter B
Cutoff Cutoff Cutoff Cutoff
Macro Macro Macro Macro Macro Macro
Brightness Brightness Timbre Timbre Feedback Feedback
Switches 7 & 8: Switches 7 & 8:
LFO 1 & 2 Stop LFO 1 & 2 Stop
393