5-4: Filter Lfo Mod - Korg KRONOS SGX-2 Parameter Manual

Table of Contents

When Link is On, or when the Filter Routing is set to Single

or 24dB/oct, all of these parameters are grayed out.

v 5–3: Page Menu Commands

The number before each command shows its ENTER +

number-key shortcut. For more information on these

shortcuts, see "ENTER + 0-9: shortcuts for menu

commands" on page 153.

5-4: Filter LFO Mod

There are three LFO-to-Frequency controls for each filter: a

basic amount (LFO Intensity), joystick -Y control of LFO

amount (JS- Y Intensity), and AMS control of LFO amount

(AMS Intensity). The three controls are summed together to

determine the final LFO amount.

5-4a: Filter A

[LFO 1, LFO 2, LFO 3, LFO 4,

This selects an LFO to modulate Filter A's cutoff frequency.

The LFO Intensity, JS -Y Intensity, and AMS are all

summed together to produce the final amount of LFO pitch

LFO Intensity

This controls the initial effect of the LFO on Filter A's cutoff

frequency, before any JS+Y or AMS modulation.

Negative (–) settings will invert the phase of the LFO.

JS -Y Intensity

Moving the joystick "down" from the center detent position,

towards yourself, produces the JS -Y controller. You can use

this to scale the amount of the LFO applied to Filter A.

• 0: Write Program. For more information, see "Write

Program" on page 153.

• 1: Exclusive Solo. For more information, see "Exclusive

Solo" on page 153.

This parameter sets the maximum amount of LFO

modulation added by JS -Y.

This selects an AMS modulation source to scale the amount

of the LFO applied to Filter A's cutoff frequency.

For a list of AMS sources, see "Alternate Modulation Source

(AMS) List" on page 1109.

This controls the depth and direction of the LFO AMS

Program P5: Filter 5-4: Filter LFO Mod

[AMS Sources]