Table of Contents
Advertisement
Control Surface - Tone Adjust
0–9f
0–9f: Tone Adjust
Tone Adjust provides two important features
simultaneously:
• It lets you use all of the sliders, knobs, and switches to
control Program parameters - like the knobs on an analog
synth, or the drawbars on an organ.
• It lets you modify Programs for use within a specific
Combi, including everything from subtle tweaks (like
changing LFO speeds) to dramatic changes (such as
selecting a different Multisample). Any changes that you
make are stored with the Combi, and do not alter the
original Program.
Each of the sixteen Timbres has its own set of tone adjust
parameters, but only one Timbre is shown at a time.
For more information, see:
• "Tone Adjust and MIDI SysEx" on page 35
• "Interaction between Tone Adjust and MIDI CCs" on
page 35
• "Absolute, Relative, and Meta parameters" on page 35
Saving Tone Adjust Edits
In Program mode, when you make edits via Tone Adjust and
then save the results, the Program data is changed–just as if
you'd edited the internal parameters directly. For more
information, see "Saving Tone Adjust Edits" on page 35.
In Combi mode, however, all Tone Adjust edits are stored
within the Combi; the Program itself is not changed. This
lets you alter the way that a Program sounds in one specific
Combi without affecting the way that it sounds in Program
mode, or in any other Combis or Songs.
Combination P0: Play 0–9: Control Surface
Timbre select
Timbre
This selects the Timbre whose Tone Adjust parameters
appear on the screen and the Control Surface. You can
switch back and forth between the different Timbres as much
as you like, without losing your edits.
This parameter is the same as the selected Timbre in
TIMBRE/TRACK mode; changing one will also change the
other.
You can use a shortcut to change the current Timbre directly
from the Control Surface, without leaving Tone Adjust
mode:
1. Press and hold the TONE ADJ./EQ button.
2. While holding TONE ADJ./EQ, press a PLAY/MUTE
or SELECT button to select a Timbre.
The PLAY/MUTE buttons select Timbres 1–8, and the
SELECT buttons select Timbres 9–16.
3. Release the TONE ADJ./EQ button.
The Control Surface and screen will change to show the
Tone Adjust parameters for the newly selected Timbre.
Auto Load Prog
When you first load a Program into a Timbre, this parameter
determines whether or not the Program's Tone Adjust
settings will be loaded as well.
These settings include the parameters assigned to each slider,
knob, and switch, along with the on/off state of any Switches
assigned to Absolute parameters.
Note that any edits you've made using Tone Adjust in
Program mode will already have been stored into the
Program's parameters. This means that the Program will still
sound the same, whether or not you load the Tone Adjust
settings.
[1...16]
[Off, On]
451
Advertisement
Table of Contents
