Korg KRONOS SGX-2 Parameter Manual page 1031

Table of Contents

High Damp [%]

Sets the amount of high-frequency attenuation.

Reverb Time [sec]

Sets the reverberation time.

Sets the reverb effect balance.

For details on the Gate graphics, see "009: Stereo Gate" on

Envelope Select

This chooses whether the gate is triggered by the signal

level, or controlled directly by the selected Dmod Source.

When Envelope Select is set to Input, the gate is controlled

by a blend of the dry audio input and the reverb output, as set

by the Input Reverb Mix.

Selects the modulation source that controls the gate when

Envelope Select is set to Dmod.

Input Reverb Mix

This mixes the dry input and reverb output signals, for

controlling the gate.

Normally, set Input Reverb Mix to Dry, so that the gate is

controlled only by the dry input. If you wish to extend the

gate time, increase the Input Reverb Mix value to include

some of the wet mix as well, and adjust the Threshold.

Sets the gate threshold level. When the signal level exceeds

the threshold, the gate opens and the reverb sound is heard.

Note that this applies only when Envelope Select is set to

Input. When the gate is controlled via Dmod, it opens when

the Dmod value is 64 or higher, and closes when the value is

63 or lower.

Sets the attack time. See "Attack" on page 914.

Sets the release time. See "Release" on page 914.

This lets you invert the gate on/off state. See "Polarity" on

This is the standard effects output section, with modulatable

control over wet/dry balance. For more information, see

"OUTPUT" on page 904.

[0.1...10.0]

[Dry, 1:99...99:1, Wet]

[Dmod, Input]

[Off...Tempo]

[Dry, 1:99...99:1, Wet]

Mono-Mono Serial 140: Reverb - Gate