Table of Contents
Advertisement
8–1f: OSC MFX Send
OSC1 Send1 (to MFX1)
Sets the volume (send level) at which the output of oscillator
1 will be sent to master effect 1. This applies only when Bus
Select (8–1c) is set to L/R or Off.
If Bus Select is set to IFX1–IFX12, the send levels to
master effects 1 and 2 are set by Send 1 and Send 2 (8–5a)
after passing through IFX1–12.
OSC1 Send2 (to MFX2)
Sets the volume (send level) at which the output of oscillator
1 will be sent to master effect 2 (see "OSC1 Send1 (to
MFX1)").
OSC2 Send1 (to MFX1)
OSC2 Send2 (to MFX2)
Sets the volume (send level) at which the output of OSC2
will be sent to master effects 1 and 2. These parameters will
be valid when Oscillator Mode is set to Double and Bus
Select is set to L/R or Off.
Note: You can use the control surface to control Send1 and
Send2. These can also be controlled from the mixer section
of the front panel, or from the P0– Control Surface page of
the LCD screen. Here's the procedure for editing these
settings from the front panel.
1. Press the CONTROL ASSIGN MIXER
TIMBRE/TRACK switch to turn it on (lit).
2. Press the MIXER KNOBS switch to select CHANNEL
STRIP.
3. Use the MIXER SELECT 1–2 switches to select the
oscillator whose send levels you want to adjust.
4. Use FX SEND 1 (knob 7) and FX SEND 2 (knob 8) to
control the send levels.
If Bus Select (IFX/Indiv. Out Assign) is set to L/R or
OFF, this will control OSC1 Send1 (to MFX1) and
OSC2 Send2 (to MFX2).
If "Bus Select (IFX/Indiv. Out Assign) is set to IFX1–12,
this will control Send1 and Send2 (P8– Insert FX page).
CC#93 scales OSC 1/2's Send 1 level, and CC#91 scales
the Send 2 level. These are controlled on the global MIDI
Channel (Global 1–1a). The actual send level is
determined by multiplying these values with the send
levels of each oscillator.
v 8–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 153.
• 0: Write Program. For more information, see "Write
Program" on page 153.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
• 2: Copy Insert Effect. For more information, see "Copy
Insert Effect" on page 166.
• 3: Swap Insert Effects. For more information, see
"Swap Insert Effect" on page 166.
[000...127]
[000...127]
[000...127]
[000...127]
Program P8: Insert Effect 8–1: Routing
141
Advertisement
Table of Contents
