070: Pitch Shifter Bpm - Korg KRONOS SGX-2 Parameter Manual

070: Pitch Shifter BPM

This pitch shifter enables you to set the delay time to match
the song tempo.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Input Level
+
Pitch Shifter
Pre
Feedback Position
Input Level
Right
Tempo
BPM
Base Note x Times
BPM
INPUT
Input Level Dmod [%]
Sets the modulation amount of the input level. See "Input
Level Dmod [%]" on page 965.
Source
Selects the modulation source for the input level.
PITCH SHIFTER
Mode
This controls whether the pitch shift will preserve tonal
quality but have a longer delay time (Slow), or be fast but
with lower quality (Fast). For details, see "Mode" on
page 965.
Pitch Shift [1/2 steps]
Sets the pitch shift amount in steps of a semitone. p.965
Fine [cents]
Sets the pitch shift amount in steps of one cent. p.965
Source
Selects the modulation source for both Pitch Shift and Fine.
Pitch Shift Amount
Sets the modulation amount for Pitch Shift.
Fine Amount
Sets the modulation amount for Fine.
DELAY
BPM
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect.
Time Over?>
The maximum delay time is 2,000msec. If the channel's
combination of BPM, Base Note, and Times exceeds this
limit, the error message "OVER!" will appear. If this occurs,
change the delay time parameters so that this message no
longer appears.
Wet / Dry
High Damp
Delay
Post
Feedback
Wet / Dry
[+/–100]
[Off...Tempo]
[Slow, Medium, Fast]
[–24...+24]
[+/–100]
[Off...Tempo]
[–24...+24]
[+/–100]
[MIDI, 40.00...300.00]
[---, OVER!]
Modulation and Pitch Shift 070: Pitch Shifter BPM
Base Note
This sets the basic delay length, relative to the BPM setting.
The values range from a 32nd note to a whole note,
including triplets.
Times
This multiplies the length of the Base Note. For instance, if
the Base Note is set to a sixteenth note, and Times is set to 3,
result will be a dotted eighth note.
Feedback Position
Switches the feedback connection. p.966.
Feedback
Sets the feedback amount. p.966.
High Damp [%]
Sets the amount of high-frequency attenuation for the
feedback path.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
[r ... w ]
[x1...x32]
[Pre, Post]
[+/–100]
[0...100]
967