Table of Contents
Advertisement
• 6: Clean Up IFX Routings. For more information, see
"Clean Up IFX Routings" on page 670.
• 7: Put Effect Setting To Track. For more information,
see "Put Effect Setting to Track" on page 670.
8–7: IFX 1–12
8–7a
8–7b
This page lets you edit the detailed parameters of the twelve
insert effect s. Use the tabs at left to select IFX1 through
IFX12.
To select different effects types, use the Insert FX or Track
View pages. For more information, see "8–5: Insert FX" on
page 628 and "8–6: Track View" on page 630.
Effects Modulation: Dmod
Most effects have one or more parameters which can be
modulated in realtime. In the KRONOS, this is called
Dynamic Modulation, or Dmod for short.
For a complete list of Dmod sources, see "Dynamic
Modulation Source List" on page 1118.
You can use different MIDI channels to control Dmod for
each effect, if desired, as selected by the Ch (Control
Channel) parameter.
8–7a: IFX1
Here you can edit the effect parameters of the insert effect
you selected in the P8– Insert FX page. Use the tabs at left to
select IFX1 through IFX12.
IFX1 On/Off
Turns the insert effect on/off. This is linked with the
on/off setting in the P8– Insert FX page.
Sequencer P8: Insert Effect 8–7: IFX 1–12
• 8: FF/REW Speed. For more information, see "FF/REW
Speed" on page 638.
• 9: Set Location (for Locate Key.) For more information,
see "Set Location (for Locate Key)" on page 639.
Ch (Control Channel)
This parameter specifies the MIDI
channel that will be used to control
effect dynamic modulation (Dmod), pan
following the insert effect (CC#8), Send
1, and Send 2.
The channel number of the MIDI track routed through this
IFX will be followed by a "*" displayed at the right of
Ch01–16. If two or tracks with different MIDI channel
settings are routed through the same IFX, this parameter
specifies which of these channels will be used to control the
effect.
Note: If you want to control an IFX to which an audio track
is routed, use a MIDI track whose channel matches the "Ch
(Control Channel)" of the effect you want to control.
All Routed: The channel of any MIDI track routed through
this effect can be used to control the effect. (Channels of
each routed track will be indicated by "*".)
Drum Kits and the MIDI Control Channel
If a Timbre is using a Drum Kit, and the Timbre's Bus Select
(IFX/Indiv. Out Assign) DKit (8–1b) is enabled, this
affects the MIDI Control Channel as well. In this case, the
Timbre's MIDI channel will be used to control any effect
[Off, On]
whose Ch is set to All Routed, regardless of the Bus Select
(Global 5–3b) settings or the settings of the DrumKit IFX
Patch page menu command.
8–7PMC
[Ch01...16, All Routed]
631
Advertisement
Table of Contents
