Korg KRONOS SGX-2 Parameter Manual page 489

Wave Sequence Quantize Trigger
This allows you to override the Program's Wave Sequence
"Quantize Trigger" setting (Program 1–1d). If you're using
multiple Programs with rhythmic Wave Sequences, you can
use this to synchronize all of the Wave Sequences at note-on.
Note that Quantize Trigger applies only when the Wave
Sequence's Mode is set to Tempo. For more information, see
"Mode" on page 800.
PRG: The setting of the program is used.
Off: "Quantize Trigger" is forced off. The wave sequence
will trigger immediately after note-on.
On: "Quantize Trigger" is forced on. The wave sequence
pattern will synchronize to eighth-note timing of the
currently-sounding wave sequence; i.e., the trigger will be
quantized.
For more information, please see "Quantize Trigger" on
page 45.
KARMA Timbre Off Control
[Normal, Timbre Off by KARMA Off, Timbre Off by
Nrm (Normal): The KARMA ON/OFF switch will not
control whether a timbre will sound. Normally you will
select Normal.
by Off (Timbre Off by KARMA Off): The timbre will
sound as usual when the KARMA ON/OFF switch is on.
The timbre will not sound when the KARMA ON/OFF
switch is off.
Use this when you want a specific timbre of multiple timbres
set to the same MIDI channel to be silent only when
KARMA is off.
by On (Timbre Off by KARMA On): The timbre will not
sound when the KARMA ON/OFF switch is on. The timbre
will sound as usual when the KARMA ON/OFF switch is
off.
Use this when you are using a KARMA Module to control
multiple timbres that are set to the same MIDI channel, and
want a specific timbre to be silent only when KARMA is on.
For example you can use this to play a two-timbre layer from
the keyboard when KARMA is off, and use one timbre to
sound the phrase when KARMA is on.
If the Status (0–1b) of each timbre is INT, you can use the
Timbre Off Control setting to stop the oscillator of each
timbre from sounding.
Timbres 02...16
These are the wave sequence and KARMA-related settings
for timbres 2 through 16. They are the same as for timbre 1.
See "Timbre 01".
v 2–5: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 153.
• 0: Write Combination. For more information, see
"Write Combination" on page 515.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
Combination P2: Timbre Parameters 2–5: Wave Sequence/KARMA
[PRG, Off, On]
• 2: Copy From Program. For more information, see
"Copy From Program" on page 515.
KARMA On]
475