Korg KRONOS SGX-2 Parameter Manual page 718

Sampling mode
0–9c
0–9c: Audio Inputs
This Control Assign setting lets you adjust the volume, pan,
and FX send settings for each of the six audio inputs: Analog
1 & 2, USB 1 & 2, and S/P DIF left and right.
Mixer Knobs
This switch controls whether the knobs show the pan
settings for all 6 inputs at once (Individual Pan), or the pan
and FX Send levels for the selected input (Channel Strip).
For more information, please see "Mixer Knobs" on
page 704.
Knobs 1–8, Channel Strip
When the Mixer Knobs switch is set to Channel Strip, the
knobs provide quick access to the selected input's Pan and
FX Send parameters.
Pan
This controls the stereo pan of the selected input. A setting
of L000 places the sound at the far left, C064 in the center,
and R127 to the far right.
Send 1
This controls the send level into FX Send 1. If the input's
Output Bus parameter is set to L/R or OFF, it scales the
programmed send level. If the Output Bus is set to IFX 1–
12, it directly controls the post-IFX send levels, overwriting
any previous setting.
Send 2
This controls the send level into FX Send 2. For more
details, see "Send 1," above.
Knobs 1–6, Individual Pan
When the Mixer Knobs switch is set to Individual Pan,
knobs 1–2 control the pan settings for analog inputs 1–2,
knobs 3–4 control USB inputs 1-2, and knobs 5–6 control
S/P DIF left and right.
704
[Channel Strip, Individual Pan]
[L000...C064...R127]
[000...127]
[000...127]
Audio Input Pan (1–6)
These control the pan for Analog 1 & 2, USB 1 & 2, and
S/P DIF left and right, respectively. A setting of L000 places
the sound at the far left, C064 in the center, and R127 to the
far right.
Play/Mute switches 1–6
The top row of switches allow you to mute any or all of the
audio inputs.
Play/Mute (1–6)
When this switch is on (LED = on), the input will be
enabled. When the switch is off (LED = off), the input will
be muted.
Solo switch and Select switches 1–6
Solo
Solo lets you isolate one or more Oscillators or Audio
Inputs, so that you hear them by themselves. It does this by
temporarily muting all non-soloed Oscillators and Audio
Inputs.
The Select switches can show and control either which audio
input is currently selected, or which inputs are soloed. The
main Solo button lets you switch back and forth between the
two views.
When Solo is Off (LED = Off), the Select switches select the
current input; when Solo is On (LED = On or blinking), the
Select switches let you solo one or more inputs.
When Solo is On, and one or more Oscillators or Audio
Inputs are soloed, the Solo LED will blink on and off to
remind you that solo is in use.
Note: The main Solo button merely changes the functions of
the Select/Solo switches. It does not enable or clear the
individual solo states.
For more information, see "Clearing all solos" on page 703,
and "Exclusive Solo menu parameter" on page 703.
[L000...C064...R127]
[Off, On]
[Off, On]