002: Stereo Compressor - Korg KRONOS SGX-2 Parameter Manual

Table of Contents

Advertisement

Effect Guide
Level
Wet
Dry
Attack
This controls the onset time of the compressor.
Level
Attack=80
Attack=20
Dry

002: Stereo Compressor

On-screen graphic, 002 Stereo Compressor
The yellow line shows the output level, relative to the input level.
This will change according to the Ratio, Threshold, and Soft Knee Width.
These lights show the relation of the control input to the Threshold and Soft Knee, in real-time.
Under (green) means the input is below the Soft Knee area, and so no compression is occurring.
Knee (yellow) means that the input is within the Soft Knee range. Within this range, as the signal
gets louder, the amount of compression will gradually increase towards the Ratio setting.
Over (red) means that the input is above the Soft Knee range, and the full Ratio is being applied.
This is a sophisticated stereo compressor that allows you to
make detailed settings, such as the level detection method
and the compression curve.
904
Dyna Compressor - Sensitivity
Sensitivity=100
Sensitivity=40
Time
Dyna Compressor - Attack
Wet
Time
Output Level
Sets the output level of the compressor.
Source
Selects the modulation source for the Output Level.
Amount
Sets the modulation amount for the Output Level.
[1...100]
OUTPUT
Wet/Dry
Sets the balance between the "wet" processed sound and the
dry input.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
This meter shows the amount of gain reduction,
in real-time. To show that the gain is being
reduced, the meter moves in the opposite
direction from the Input meter.
The red marks show the Threshold setting.
The light gray area shows the Soft Knee Width.
Notice how the slope of the yellow line changes
as it passes through this range.
The red marks show the Threshold setting.
Stereo In - Stereo Out
Left
Envelope Source
Right
[Dry, 1:99...99:1, Wet]
Delay
Compressor
Side EQ
Envelope - Control
+
Envelope - Control
Envelope Select
Delay
Compressor
FX Control BUS 1
Detection Mode
FX Control BUS 2
Lookahead
[0...100]
[Off...Tempo]
[+/–100]
[Off...Tempo]
[+/–100]
Wet / Dry
Gain Adjust
Side Chain Monitor
Gain Adjust
Wet / Dry

Advertisement

Table of Contents
loading

Table of Contents