Korg KRONOS SGX-2 Parameter Manual page 555

hold down the SEQUENCER REC/WRITE switch to delete
the automation events that occur while you're holding down
that switch.
0–5b: Recording Setup (Audio Track)
Automation Only
On (checked): Only audio track automation events will be
recorded. Audio events will not be changed.
Off (unchecked): Both audio track automation events and
audio events will be recorded.
Auto Input
This switches the monitor channel (REC Source/ track
playback) for the audio track selected in Track Select. See
the table that follows.
If "Multi REC" is on, this applies to all tracks whose
Play/Rec/Mute is set to REC.
On (checked): When performing auto/manual punch-in
recording, the audio track selected in Track Select will be
monitored via its REC Source during the measures being
recorded, and the track playback will be monitored during
measures that are not being recorded.
For the audio tracks not selected in Track Select, you will
always be monitoring the track playback.
When performing auto/manual punch-in recording with
"Multi REC" on, audio tracks whose Play/Rec/Mute is set
to REC will be monitored via REC Source during the
measures being recorded, and will automatically switch to
monitoring the track playback during measures that are not
being recorded.
For the audio tracks that are not set to REC, you will always
be monitoring the track playback.
Off (unchecked): The audio track selected in Track Select
will always be monitored via its "REC Source."
For the audio tracks not selected in Track Select, you will
always be monitoring the track playback.
If "Multi REC" is on, you will always be monitoring the
REC Source of audio tracks whose Play/Rec/Mute is set to
REC.
For the audio tracks that are not set to REC, you will always
be monitoring the track playback.
Sequencer P0: Play/REC 0–5: Preferences
Audio track monitor channels
(Line: REC Source, Track: track playback)
[Off, On]
Track Select
track
Tracks
[Off, On]
other than
"Track
Select"
Source Direct Solo
On (checked): Only the signal of the bus line specified by
REC Source will be output to the L/R jacks and the
headphone jack. Check this if you want to monitor only the
sound that's being recorded. When using Multi REC, you'll
hear the sound from the REC Source buses whose
Play/Rec/Mute setting is set to REC.
Off (unchecked): The L/R (post-TFX) and bus line signal(s)
specified by Source Bus will be sent from the L/R jacks and
the headphone jack as specified by the Audio Input "Bus
Select (IFX/Indiv. Out Bus Select)" (8–3a) and post-IFX
Bus Sel. (8–5a) settings. This is the normal state.
Note: If the Source Bus is L/R, this setting is ignored; the
L/R (post-TFX) signal is output from the L/R jacks and the
headphone jack.
Rehearsal
On (checked): Recording to the audio track(s) will be
simulated (recording will not actually occur).
The monitoring during rehearsal will depend on the "Auto
Input" setting. If "Auto Input" is checked, you will monitor
the external input between punch-in and punch-out, and
monitor the already-recorded sound at other times.
For example if you set punch-in at 005 (measure 5) and
punch-out at 008 (measure 8), you will monitor the already-
recorded sound during measures 1 to 4 and measures 9 to the
end, and monitor the external input during measures 5 to 8.
0–5c: Audio Track Recording Level [dB]
Recording Level, Name, Take, and Take No. settings for
the sixteen audio tracks are not maintained separately for
each song; instead, they apply globally to the entire
Sequencer mode.
This area displays the settings of the track selected in Track
Select (for single track recording) or the settings of the
tracks whose Play/Rec/Mute button is set to REC (for multi-
track recording).
Audio Tracks 1...4
Recording Level 1...4
Level Meter 1...4
This adjusts the final level of the signal being recorded from
the REC Source to the audio track. Adjust the level
optimally without allowing the level meter to reach the
"CLIP !" indication.
During Punch Rec
On Line Track Line Track Line
Off Line Line Line Line
On Track Track Track Track Track Track
Off Track Track Track Track Track Track
[–Inf, –72.0...+18.0]
Track
*
Line Line
[Off, On]
[Off, On]
541