Copy Mfx/Tfx - Korg KRONOS SGX-2 Parameter Manual

2. Alternatively, you can execute this command from the
Track View page.
3. Select "Clean Up IFX Routings" to open the dialog
box.
4. Press the OK button to execute the Clean Up IFX
Routings command, or press the Cancel button if you
decide to cancel.
In this example, the discontinuous chain
IFX1 IFX5 IFX11 IFX12 has been reorganized into
Program: Page Menu Commands Copy MFX/TFX
IFX1 IFX2 IFX3 IFX4, and the vacant slots (000:
No Effect, unless located within a chain) have been
rearranged consecutively.
At this time, the following parameters are automatically
adjusted to maintain the existing routings.
• Routing: Bus Select
• Routing- Page Menu: DKit Patch (Combi/Seq)
If the program uses a drum kit, and the Routing page
"Use DKit Setting" is on, you may have to change the
Bus Select setting for each key of the drum kit in order to
reproduce the previous routing status.
In such cases, don't use the "Clean Up IFX Routings"
command. Instead, rearrange the IFX slots by making the
appropriate Chain to settings or by using the "Copy
Insert Effect" or "Swap Insert Effect" commands.

Copy MFX/TFX

Copy MFX/TFX is available on all of the MFX/TFX pages.
This command lets you copy any desired effect settings from
Program, Combination, Song, or Sampling mode.
1. Select "Copy MFX/TFX" to open the dialog box.
2. In "From," select the copy source mode, bank, and
number.
You can also use the BANK SELECT switches to select
the desired bank.
If you press the "Set To Current" button, the currently
selected mode, bank, number, and MFX/TFX (edit cell)
will automatically be assigned to the "From" field. This is
useful when you're trying out other effect settings and
want to temporarily copy previously-edited MFX/TFX
settings to another vacant effect slot.
3. Select the effect that you want to copy.
You can copy from an insert effect by selecting IFX1–12.
If you copy from an insert effect, the result may not be
exactly the same, due to differences in routing and level
settings.
If you select MFX1 or MFX2, the Return level will be
copied at the same time.
You can copy settings from a total effect by selecting
TFX1 or TFX2.
If you check All MFXs, all master effect settings will be
copied.
If you check All TFXs, all total effect settings will be
copied. Master Volume settings will not be copied.
4. In "To," specify the copy destination master effects or
total effects.
169