Table of Contents
Advertisement
Sequencer mode
If Stereo Pair is on and you've selected Indiv.1/2, the Indiv.
bus 1 will be sent to odd-numbered tracks, and Indiv. bus 2
will be sent to even-numbered tracks.
REC Source
= Indiv.1, 2 (3, 4)
Sequencer Playback
Keyboard
STEREO
This is shown if Stereo Pair is on.
Play/Rec/Mute
Use this to mute an audio track, or to select the recording
tracks for multi-track recording. During playback, or for
single-track recording (normal recording), it is possible only
to select Play or Mute for tracks (playback tracks) other than
the recording track. For multi-track recording, tracks can be
set to Play, Rec, or Mute. The setting will alternate each time
you press the Play/Rec/Mute button.
Play: The track will play.
Rec: This will be displayed during single-track recording
(normal recording). It cannot be selected.
When you use multi-track recording (the Preferences page
"Multi REC" is on), select REC for the tracks that you wish
to record. You can specify REC for up to four tracks.
Mute: The track will be muted (silent).
Note: You can use the control surface to control
Play/Rec/Mute. You can also make this setting from the front
panel mixer section or from the P0– Control Surface page of
the LCD. The procedure given below describes how to make
these settings from the front panel.
1. Press the CONTROL ASSIGN MIXER AUDIO
switch to select tracks 1–8 or 9–16.
2. Use the MIX PLAY/MUTE 1/9 – 8/16 switches to
switch the Play/Rec/Mute status of each track. (You
can't select REC for single-track recording.)
Solo On/Off
This turns the Solo function on/off.
Only tracks that are set to Solo On will sound. Other tracks
will be muted.
The setting will alternate on/off each time you press the Solo
button.
The operation will depend on the setting of the Exclusive
Solo menu command, as described below:
536
L/R
Bus
Insert
Effects
Bus = L/R or IFX1-12
[Play, Rec, Mute]
[On, Off]
REC
Indiv.
1,2,3,4
1,2, 3, 4
REC Source
Indiv.1
Indiv.2
Insert
Effects
If the Bus Select of an audio track is set to Indiv. 1 or 2, the Rec input will
automatically be muted in order to avoid a feedback loop. If you route the signal
to IFX, the same thing will occur if you send the post-IFX signal to REC Bus 1 or 2.
Exclusive Solo off: Multiple tracks can be soloed. The solo
setting of each track will change each time you press its Solo
On/Off button.
Exclusive Solo on: When you press a Solo On/Off button,
only that track will be soloed.
Note: You can use the control surface to turn Solo on/off.
You can also make this setting from the front panel mixer
section or from the P0– Control Surface page of the LCD.
The procedure given below describes how to make these
settings from the front panel.
1. Press the CONTROL ASSIGN MIXER AUDIO
switch to select tracks 1–8 or 9–16.
2. Press the SOLO switch.
3. Use the MIX SELECT 1/9–8/16 switches to turn Solo
on/off for each track.
Note: The Solo function applies to MIDI tracks 1–16, audio
tracks 1–16, audio inputs 1–2, and S/P DIF input L, R.
Note: If even one track is being soloed, the SOLO switch
LED will blink.
Tip: To turn Solo off for all tracks, hold down the RESET
CONTROLS switch and press the blinking SOLO switch.
Solo settings are not saved with the song.
Recording Audio Track Pan and Volume
The pan and volume that you specify here will be used when
you playback or record from the beginning of the song. If
you modify these settings while recording, your changes will
be recorded as automation event data on the automation
track for each audio track, and the pan and volume data will
change accordingly during playback. You can also change
the settings during playback. However when the song
reaches a location where pan or volume data was recorded,
the settings will change accordingly.
Pan
This specifies the pan of audio track.
L000...C064...R127: L000 is hard left, and R127 is hard
right.
Recording (Multi REC)
CLIP !
HDR Track (Mono)
HDR Track (Mono)
Set Play/Rec/Mute
to Rec
Pan
Level
Bus = L/R or IFX1-12
Monitor
L/MONO
R
[x] Source Direct Solo
INDIV.1
AUDIO OUTPUT
INDIV.2
[L000...C064...R127]
AUDIO OUTPUT
HEADPHONES
Advertisement
Table of Contents
