Korg KRONOS SGX-2 Parameter Manual page 988

Table of Contents

Effect Guide

The rotor carries the low frequencies of the Rotary Speaker.

Its parameters are identical to those of the Horn, above.

Acceleration

Deceleration

Start Acceleration

Stop Deceleration

Balance and Tone

Horn/Rotor Balance

Sets the volume balance between the high-frequency horn

and low-frequency rotor.

Speaker Simulator

Switches speaker simulation on/off.

Match CX-3 Tone

When using this effect on a CX-3 Program, this setting will

adjust the tone appropriately for the CX-3's Amp Type. If

AmpType = Type1 or 2, use the corresponding Amp1 or 2

setting. If Amp Type = Pre Amp, turn this parameter Off.

These settings model two pairs of stereo microphones

recording the rotary speaker–one pair each for the horn and

rotor. In the real world, this would require an elaborate setup,

or even splitting the rotary speaker into two–but it's

relatively easy in the software world of the KRONOS, and it

gives you separate control over the tone and stereo spread of

the high and low frequencies.

The other rotary speaker effects have only one pair of mics,

but are otherwise similar; for more information, see "MIC"

on page 971.

Horn Distance

Rotor Distance

Rotor Spread

This is the standard effects output section, with modulatable

control over wet/dry balance. For more information, see

"OUTPUT" on page 904.

[Rotor, 1...99, Horn]

[Off, Amp 1, Amp 2]