Set Song Length - Korg KRONOS SGX-2 Parameter Manual

Sequencer mode
In the Set Event Filters dialog box, select the types of
automation event data that you want to view or edit in the
automation edit window.
Check each type of event (Audio, Pan, EQ, Volume,
Send 1/2) that you want to see.
Audio events are shown in this window for reference, but
they cannot be edited here. To edit them, use the "Audio
Event Edit" command.
2. Press the OK button to access the Automation Edit
dialog box.
3. Measure and Index located in the top line of the dialog
box show the measure for editing and the index
number of an event within that measure; this event is
shown at the top of the list of events.
You can use the scroll bar at right to move to the event
you want to edit.
4. Select the event you want to edit, and use the VALUE
controller to input the desired values.
• You can move the location of the event within the
measure by editing the "Beat Tick" value.
• To edit the event data, input the desired values for each
event.
5. You can press the buttons located at the bottom of the
dialog box to edit events as follows.
• Inserting an event
Select the location "Beat Tick" at which you wish to
insert an event, and press the Insert button to insert an
event.
• Deleting an event
Select the event that you wish to delete, and press the Cut
button to delete the event.
• Moving an event
You can use the Cut button and Insert button to move an
event (by "cut and paste").
654
Use the Cut button to delete the event that you wish to
move, then use the Insert button to insert it at the desired
location.
You can also move an event by modifying its "Beat Tick"
value.
• Copying an event
Select the event that you wish to copy, and press the Copy
button. Then select the copy destination and press the
Insert button to insert the event at that location.
6. You can press the Play button to play back an audio
event. During playback, an indication of "Stop" will
appear, and you can stop playback by pressing this
button.
Playback will also stop when you reach the end of the
audio event. This is available only if you've selected an
audio event.
7. When you're finished with automation editing, press
the Done button.
If desired, you can press the COMPARE switch to return
to the state prior to automation editing.
The following table shows the types of "Automation Edit"
events and the range of values.
Kind Value
Region name
(display only)
(Audio events)
Volume 000...127
Pan 000...127
Send1 000...127
Send2 000...127
EQ Bypass On, Off
EQ Input Trim 00...99
EQ High Gain –18.0...+18.0
EQ Mid Freq 100...10.00k
EQ Mid Gain –18.0...+18.0
EQ Low Gain –18.0...+18.0

Set Song Length

This command changes the length of the specified song.
When it is executed, the length of the master track will
change, and the number of measures played will change.
1. Select "Set Song Length" to open the dialog box.
2. In "Length," specify the length of the song.
3. To execute the Set Song Length command, press the
OK button. To cancel without executing, press the
Cancel button.
Value2
E:001:00.000...
999:16.479(Display only)
(End of an audio event:
measure, beat, clock)