Foot Pedal Assignments - Korg KRONOS SGX-2 Parameter Manual

Foot Pedal Assignments

You can connect a pedal (such as the optional Korg XVP-10
or EXP-2) to the rear-panel ASSIGNABLE PEDAL input,
and then use it to control a wide variety of functions, as
described below.
This setting is made for the entire KRONOS, on the Global
P2–1 Controller page.
A note on MIDI CCs
Some of the assignments include MIDI CCs, which are
transmitted whenever the knob is moved. Note that the MIDI
CCs can still be received even if they are not assigned to a
physical controller.
RT Knobs 5-8 and SW1/2 are special cases, since these can
themselves be assigned to different MIDI CCs. If the
footswitch is assigned to duplicate these controls, it will also
use their CC assignments.
List of Foot Pedal assignments
Off
This setting disables the pedal.
Master Volume
This controls the volume of the main stereo outputs, after the
Total Effects. It does not affect Individual Outputs 1–4.
This also transmits the Universal System Exclusive Master
Volume message [F0H, 7FH, nn, 04, 01, vv, mm, F7H].
For more information, see the diagram under "Master
Volume Slider" on page 29.
Foot Pedal (CC#04)
You can use this general-purpose controller as an AMS or
Dmod source. Note that you'll also need to assign Foot
Pedal (CC#04) to control the desired parameter within the
Program or Effect.
Portamento Time (CC#05)
Controls the speed at which portamento will change the
pitch.
Volume (CC#07)
Control the volume of a Program, Combination, or of a
MIDI track in Sequencer modes.
Post IFX Pan (CC#08)
Control the pan after passing through the Insert Effect.
Pan (CC#10)
Control the pan of a Program, of a timbre in a Combination,
or of a MIDI track in Sequencer modes.
Expression (CC#11)
Expression is a secondary volume control, which you can
use to scale level without affecting the main volume settings
or CC#7 values. For more information, see "Expression
(CC#11)" on page 1122.
Controller Assignments Foot Pedal Assignments
FX Control 1 & 2 (CC#s12 & 13)
These assignments are intended for Effect Dynamic
Modulation (Dmod). Note that you'll also need to assign FX
Control 1 or 2 to control the desired parameter within the
Effect.
MFX Send 1 & 2 (CC#s 93 & 91)
These control the send levels to Master Effects 1 and 2,
respectively.
CC#s 93 and 91 actually control send levels in two different
places: the sends directly from the Program OSC or EXi, and
the send levels of the last Insert Effect in the chain which
matches the CC's MIDI channel.
JS+Y (CC#01)
This duplicates the function of JS+Y. Whatever JS+Y is
assigned to control, the pedal will control as well.
JS–Y (CC#02)
This duplicates the function of JS–Y. Whatever JS–Y is
assigned to control, the pedal will control as well.
Ribbon (CC#16)
This duplicates the function of the ribbon controller.
Whatever the ribbon is assigned to control, the pedal will
control as well.
Value Slider (CC#18)
Pedal operation will control the effect of the VALUE slider.
RT Knob 1–8
This duplicates the function of the selected REAL TIME
KNOB. Whatever the knob is assigned to control, the pedal
will control as well.
KARMA RTC Slider1–8
This duplicates the function of the selected KARMA
SLIDER. Whatever the slider is assigned to control, the
pedal will control as well.
1125