Korg KRONOS SGX-2 Parameter Manual page 464

Combination mode
Knobs 1–8
Knobs 1–4 all have dedicated functions which correspond to
MIDI CCs. Knobs 5–8 can be assigned to a wide variety of
functions, many of which also have corresponding MIDI
CCs.
When you move the knob, it will send the corresponding
MIDI CC to all Timbres on the Global Channel. (To edit
individual Programs, use Tone Adjust instead.)
Also, when the CC is received via MIDI or generated by
KARMA, the knob value will change to match the CC value.
Note that the Knob 1–8 settings of the individual Programs
do not apply in Combi mode.
Unless otherwise noted, "scaling" means that the parameters
are at their programmed values when the controller is at 64,
at their minimum when the controller is at 0, and at their
maximum when the controller is at 127. For another look at
this, see the diagram below.
CC scaling of parameters
9 9
Parameter
V alue
As Programmed
0 0
0
Knob 1: CUTOFF (CC#74)
This knob scales the cutoff frequencies of Filters A and B,
and transmits and receives MIDI CC #74.
Knob 2: RESONANCE (CC#71)
This knob scales the resonance of Filters A and B, and
transmits and receives MIDI CC #71.
Knob 3: Filter EG Intensity (CC#79)
This knob scales the effect of the Filter EG on the cutoff
frequencies of Filters A and B. It also transmits and receives
MIDI CC#79.
Knob 4: EG Release (CC#72)
This knob scales the release time of the Filter and Amp EGs,
and transmits and receives MIDI CC#72.
Knobs 5–8
You can set knobs 5–8 to a wide variety of modulation
functions, using the Controller Setup page (P1–8).
Many of the functions scale a particular set of Program
parameters. All of the settings also correspond to MIDI
messages–usually CCs.
KARMA SCENES 1-8
KARMA Scenes
A KARMA SCENE includes the settings for all of the
KARMA SLIDERS and SWITCHES. Each Combi can
contain up to eight Scenes.
450
6 4 1 2 7
C C V alue
[000...127]
[000...127]
[000...127]
[000...127]
[000...127]
[1...8]
To select a Scene, just press its switch - you'll see all of the
KARMA SLIDERS and SWITCHES update instantly to
their new values.
KARMA SWITCHES 1-8
KARMA Switches
These switches control KARMA Performance or GE
(Generated Effect) Real-Time Parameters, as assigned on the
KARMA Perf RTP and GE RTP pages.
The switches indicate the current on/off status.
The parameters assigned to the switches and their on/off
status can be edited in the GE RTP page or the KARMA Perf
RTP page.
KARMA SLIDERS1-8
KARMA Sliders
These sliders control KARMA Performance or GE Real-
Time Parameters, as assigned on the KARMA Perf RTP and
GE RTP pages.
The current values are shown under the sliders. The
parameters assigned to the sliders and their value can be
edited in the GE RTP page or the KARMA Perf RTP page.
Master Volume Slider
Master Volume
This controls the volume of the main stereo outputs, after the
Total Effects. It does not affect Individual Outputs 1–4. For
more information, see the diagram "Master Volume" on
page 447.
[Off, On]
[000...127]
[000...127]