048: Stereo Flanger - Korg KRONOS SGX-2 Parameter Manual

Effect Guide

048: Stereo Flanger

This effect gives a significant swell and movement of pitch
to the sound. It is more effective when applied to a sound
with a lot of harmonics. This is a stereo flanger. You can add
spread to the sound by offsetting the phase of the left and
right LFOs from each other.
Stereo In - Stereo Out
Left
Right
LFO Shape
LFO: Tri / Sine
FLANGER
Delay Time [msec]
Sets the delay time from the original sound.
Depth
Sets the depth of LFO modulation.
Feedback
This controls the intensity of the flanger effect. Positive and
negative values create different timbres.
Mixing the processed and dry signals via Wet/Dry will
enhance the effect. For maximum intensity, set Feedback
and Wet/Dry so that they are either both positive or both
negative; this emphasizes the flanger's harmonic peaks.
High Damp [%]
This sets the amount of high-frequency attenuation in the
flanger's feedback loop. Increasing the value will reduce
high-frequency harmonics.
LFO
Waveform
Selects the LFO Waveform.
Shape
Changes the curvature of the LFO Waveform. p.924.
Phase [degrees]
Sets the LFO phase difference between the left and right. See
"Phase [degrees]" on page 923.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
948
Wet / Dry
Flanger
Feedback
High Damp
Flanger
Wet / Dry
LFO Phase
[0.0...50.0]
[0...100]
[+/–100]
[0...100]
[Triangle, Sine]
[+/–100]
[–180...+180]
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on page 921.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO, or
one of the Common FX LFOs. For more information, see
"LFO Type" on page 921.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
OUTPUT
Wet/Dry [–Wet...–1:99, Dry, 1: 99...Wet]
Sets the balance between the "wet" processed sound and the
dry input. Negative values invert the phase of the wet signal.
This interacts with Feedback; for more information, see
"Feedback" on page 948.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
[Check-box]
[MIDI, 40.00...300.00]
[r ... w ]
[x1...x32]
[+/–180]
[Off...Tempo]
[+/–100]